PROJECT DESCRIPTION

LF12 KEGS WASHER

Made of stainless steel, stainless steel pumps with Teflon seals, stainless steel pneumatic valves, Telemecanique electrical equipment. The machine carries out 1 wash and CO2 injection.

Operation is semi-automatic managed by PLC.

Machine connections:

1. Mains water
2. Electrical connection 400V - 50 Hz
3. Electrical absorption 2.5 kW
4. Compressed air
5. CO2

The cycle is composed as follows:

• Manual attachment of the drums (n° 2 per cycle)
• Start cycle
• From this moment the cycle is totally automatic
• It begins with the opening of the drain valves to empty the drums of any residues
• An initial passage of mains water and relative emptying via compressed air
• Pump 1 start for a wash with alkaline based detergent preheated to 80°C with electric resistance
• Water drain in tank 1 and detergent recovery, blowing with compressed air
• Mains water opening for final rinse
• Discharge of disposable water and blowing with compressed air
• Injection of CO2 gas into the drums up to the desired pressure
• Green light turns on which identifies the end of the wash and that the steps have been carried out successfully
• Manual detachment of the stems

From this moment the drum washer is ready for a new cycle.
The cycle lasts approximately 4 minutes therefore approximately 30 30 liter drums per hour are washed and disinfected.

Dimensions 1200x800x900 mm.
Weight 180 kg.

LF32 KEGS WASHER

Made of stainless steel, stainless steel pumps with Teflon seals, stainless steel pneumatic valves, Telemecanique electrical equipment. The machine carries out 1 wash and CO2 injection.

Operation is semi-automatic managed by PLC.

Machine connections:

1. Mains water
2. Electrical connection 400V - 50 Hz
3. Electrical absorption 2.5 kW
4. Compressed air
5. CO2

The cycle is composed as follows:

• Manual attachment of the drums (n° 2 per cycle)
• Start cycle
• From this moment the cycle is totally automatic
• It begins with the opening of the drain valves to empty the drums of any residues
• An initial passage of mains water and relative emptying via compressed air
• Pump 1 start for a wash with alkaline based detergent preheated to 80°C with electric resistance
• Water drain in tank 1 and detergent recovery, blowing with compressed air
• Mains water opening for final rinse
• Discharge of disposable water and blowing with compressed air
• Injection of CO2 gas into the drums up to the desired pressure
• Green light turns on which identifies the end of the wash and that the steps have been carried out successfully
• Manual detachment of the stems

From this moment the drum washer is ready for a new cycle.
The cycle lasts approximately 4 minutes therefore approximately 30 30 liter drums per hour are washed and disinfected.

Dimensions 1200x800x900 mm.
Weight 180 kg.